The objective of this work is to study the ability of friction surfacing to deposit metal alloys that are difficult to process with traditional methods. Creep and neutron irradiation resistant oxide dispersion strengthened (ODS) materials cannot be produced via conventional casting route due to insolubility of the oxidic and metallic alloy constituents, causing unintended inhomogeneousoxide dispersion and material behavior. Increasing silicon content of Iron-Silicon (Fe-Si) improves electromagnetic properties but embrittles the material significantly and the fusion based manufacturing methods unable to process this steel. The solid-state nature of the friction surfacing process offers a potential alternative processing route to enable wider usage of difficult to process alloy systems. Both ODS and Fe-Si materials are available in powder forms. While the existing literature in friction surfacing focuses on depositing composites by incorporating small quantities powders through holes in consumable rod, this is a first study that shows a large charge of powdercan be converted to a homogeneous fully consolidated deposit in friction surfacing. A novel methodology is used that incorporates the high portion of powder feedstock into hollow consumable friction surfacing rods (up to 35% volume fraction). It was found that fully consolidated deposits can be produced with powder feedstocks using proposed methodology. A recrystallized, homogeneous, equiaxed microstructure was observed in Fe-Si 6.8 wt% and a new generation FeAlOY ODS alloy deposits processed with hollow stainless-steel friction surfacing rods. Both powder and rod material plasticize and deposit without bulk intermixing.